Connecting to your Matrox Iris GTR desktop 33
Connecting to your Matrox Iris GTR desktop
From your smart camera‘s desktop, you can launch the MILConfig utility (to
configure updates, assist in troubleshooting your runtime application with Matrox
technical support, and set default values), as well as access files stored on your
smart camera.
The following instructions are for Matrox Iris GTR with Matrox Design Assistant.
If you have Matrox Iris GTR with MIL-only, it has Windows 10 IoT, so you can
set up remote access to your camera using the Windows Remote Desktop
Connection utility.
Accessing your Matrox Iris GTR desktop remotely
If you do not want to keep a keyboard, mouse, and monitor connected to your
Matrox Iris GTR, once your smart camera is on your network, you can connect
to your Matrox Iris GTR remotely by using a virtual network computing (VNC)
program. Several VNC programs are available on the Internet. A few choice
examples are available to download directly from your smart camera. To download
and install one of these programs, perform the following:
1. For Matrox Iris GTR with Design Assistant users, go to the following web address:
Replace XXXX with the last four digits of your smart camera’s MAC address, or
if you have changed the camera’s device name, replace GTR32XXXX with its new
name. You can also replace GTRXXXX with the smart camera’s IP address.
2. Select the installer that best matches your needs.
Follow all on-screen instructions. Refer to the provided documentation for
assistance.
Logging in When using VNC for the first time, you must log into your Matrox Iris GTR
using the default user account:
http:\\GTR32XXXX:8080
User name: MtxUser
Password: Matrox
To Next Page
Loading...
