32 Chapter 2: Powering and connecting to your Matrox Iris GTR
3. When the Matrox Design Assistant configuration portal loads, go to the
Administration page by clicking on the gear button.
4. Click on the TCP/IP tab.
5. Enter the IP address, subnet mask, and gateway address in the spaces provided.
When done, click on the Save settings button.
Your IP address is now changed.
Using the Matrox Iris GTR Discovery utility for Matrox Iris GTR
If you do not know your Matrox Iris GTR’s IP address, you can use the Matrox
Iris GTR Discovery utility to access it and change its IP address; to do so, perform
the following:
1. On your development computer (where Matrox Design Assistant is installed),
launch the MIL Control Center utility.
2. In the MIL Control Center utility, select Design Assistant Tools for the version
of Matrox Design Assistant.
3. In the Design Assistant Tools directory, select and run the Matrox Iris GTR
Discovery utility (IrisGTRDiscovery).
The Matrox Iris GTR will find all the Matrox Iris GTRs on the same subnet, and
allow you to modify their communication settings.
To Next Page
Loading...
