Open-wire connectors reference 131
The pinout for the ICS3 connector is as follows:
Wire-
terminal
Description Matrox Iris GTR
signal sent
Routed through
the Matrox
Iris GTR
breakout board’s
camera connector
Connection
to be made
with your
ICS3 device
NPN Auxiliary signal 0 (output). Note that this wire-terminal is active
only if the Output-to-ICS3 selector switch (SW8) is set to NPN.
If used, the PNP wire-terminal should remain disconnected.
AUX_OPTOIND_OUT0 Violet Pin 4 (black)
PNP Auxiliary signal 0 (output). Note that this wire-terminal is active
only if the Output-to-ICS3 selector switch (SW8) is set to PNP.
When the PNP wire-terminal is connected, the voltage observed on
the pin is inverted when compared to the voltage observed on the
auxiliary output signal pins (OUT0, OUT1, and OUT2). That is,
when the auxiliary output signal is set to On, the signal on the PNP
wire-terminal is high; when it is set to Off, the signal on the PNP
wire-terminal is low. Note that this connection requires that you
enable the on-board pullup for OUT0 by turning output pullup
resistor switch 3 (SW6[3)] to ON.
If used, the NPN wire-terminal should remain disconnected.
AUX_OPTOIND_OUT0 Violet Pin 4 (black)
Analog Analog intensity (dimming) control signal. Note that this
wire-terminal can be connected, even if the NPN, PNP, and +VDC
wire-terminals are disconnected.
Note that, if using the output connector (J6) instead of this
connector for the controlling auxiliary output signal, the Analog pin
is still available for use with your third-party lighting controller.
AUX_AREF_OUT7 Blue Pin 5 (Grey)
-VDC Negative pin of the power provided to the third-party lighting
controller. Note that this wire-terminal (-VDC) must always be
connected.
Gray-pink Pin 3 (Blue)
+VDC Positive pin of the power provided to the third-party lighting
controller. The +VDC pin must be used in conjunction with the
-VDC pin, and only if you want your third-party lighting controller to
be powered by the Matrox Iris GTR breakout board.
Green Pin 1(brown)
To Next Page
Loading...
