Matrox Iris GTR Windows 10 IoT Enterprise configuration utility 89
❖
Note that the default mass storage device shipped with your Matrox Iris GTR
(an eMMC) has 2 partitions labeled as follows:
- RECOVERY. This partition is not assigned a drive letter.
- MTXGTR. This partition is assigned to the C: drive.
The RECOVERY partition houses the Matrox Iris GTR Rescue utility and does
not get reformatted if you restore a backup .wim file from the Matrox Rescue
utility console. However, if you use a rescue USB key with a captured backup .wim
file (W10EGTR.wim), or restore to a factory default settings file
(W10Ex64GTR.wim), then both the RECOVERY and MTXGTR partitions are
reformatted.
❖ Note that when operating in system recovery mode (that is, using the Matrox
Iris GTR Rescue utility), the RECOVERY partition is assigned to the C: drive,
and the MTXGTR partition is assigned to the D: drive.
To perform any of the backup, capture, or restore tasks, you must access your
Matrox Iris GTR directly; you cannot perform these tasks remotely. To access the
camera directly, connect a display device, keyboard, and mouse to your Matrox
Iris GTR. For information, refer to Powering and connecting to your Matrox
Iris GTR section, in Chapter 2: Powering and connecting to your Matrox Iris GTR.
For the latest information on backup, capture, and restore features, refer to the
ResQReadme.txt file, found on the C: drive of your Matrox Iris GTR, or the
WinReadme.txt. found on the System and Drivers utilities DVD.
To Next Page
Loading...
