224
Chapter 17, Using Matrox MXO2 with Telestream Wirecast
1 Connect the video and audio input sources that you want to record to the
corresponding inputs on your Matrox hardware.
2 To configure your source settings, choose Sources > Show Sources
Settings
.
3 In the Source Settings dialog box, under MATROX INPUT DEVICES,
select the Matrox device that you want to configure, and then specify your
source settings for recording as follows:
$ From the Video Format list, select the video format that matches your
source video. If your video input is not presently connected because you
want to connect it later during your recording session, select the video
format that matches the input that you’ll be connecting. For a list of the
video input formats supported on the various MXO2 inputs, see
“Supported input formats” on page 306.
To Next Page
Loading...
