Operating Instructions – Labmaster
©
130 and MB20G Systems
Instruction Manual
Chapter 2: Liability, Warranty & Safety
© MBraun, Inc. Edition 1/2007 Page 2-6
2.10 Safety – Symbols Used on the System
The following symbols refer to MBRAUN components and parts. However, components and
parts of sub-suppliers may show other symbols, not expressly mentioned or referred to in this
manual. The following caution and command symbols may be seen on the system:
General hazard Electrical hazard Fire hazard
Toxic hazard Explosion hazard Pressurised gas hazard
Wear safety mask Wear safety goggles Wear protective gloves
The owner of the system is responsible to place adequate danger
signals and labels in suitable places. This applies in particular to
signals and labels concerning process chemicals used. Regardless
of the number of caution symbols and information placed on or
around the system, all safety instructions of this manual must be
observed!
2.11 Safety – Emergencies
In case of an emergency, please observe the following instructions:
1. Immediately shutdown the system using the main power switch.
2. Disconnect the system from all gas supplies.
3. Refer to the material safety data sheets for information on treating the emergency.
Contact the appropriate emergency response personnel in the area and/or listed on the
material safety data sheets.
Do not disconnect the water supply for systems containing
components requiring a cooling water source.
Prior to restarting, the system must be fully checked for safety, contact the MBRAUN Service
Department after the emergency has been rectified.
In addition to the information contained in this manual all local
health, safety and environmental guidelines must be followed.
To Next Page
Loading...
