Operating Instructions – Labmaster
©
130 and MB20G Systems
Instruction Manual
Chapter 7: Installation
© MBraun, Inc. Edition 1/2007 Page 7-12
Slide hand out of the glove and work the cuff
of the glove into the groove in the gloveport
closest to the glass. At this time the thumb
position can still be adjusted by rotating the
cuff of the glove.
Secure the glove with two o-rings.
Place the o-ring in the top of the second
groove from the glass and in one smooth
motion pull down across the circumference
of the gloveport.
Repeat the process for the remaining glove(s)
and o-ring(s).
7.10 Connecting the Freezer and Compressor
General Information
This section applies only to systems that are equipped with freezers.
Remove the cover from the horizontal wire
track located on the rear of the stand.
To Next Page
Loading...
