4
Operator's Manual English 63
Figure 50. SET ALARM LIMITS - Default Settings
Note: Four sensors are shown even if fewer are in use.
3. To set upper alarm limits:
a. Press ON for UPPER LIMITS. A second scale appears for each sensor.
Figure 51. SET ALARM LIMITS - Upper Limits On
b. Next to a sensor, press and hold the slider for the UPPER limit, drag it to the
desired value, and release. You can set different values for each sensor.
4. To set lower alarm limits:
a. Press MANUAL or AUTO for LOWER LIMITS, as desired.
b. Next to a sensor, press and hold the slider for the LOWER limit, drag it to the
desired value, and release. You can set different values for each sensor.
5. Press CLOSE. The new alarm limits take effect immediately.
Note: Alarm limit settings remain in effect across power cycles.
4.11.3. Changing the Alarm Volume
Warning: Do not silence, pause, or decrease the volume of audible alarms if patient safety
could be compromised.
To Next Page
Loading...
