HARDWARE MANUAL Document reference MAMPS-HW/E
VM600 machinery protection system (MPS) Edition 18 - March 2022
8-20
Installation procedure for cards
INSTALLATION
8.4.3 Setting the IP address of the CPUM card
The IP address of the CPUM card must be defined for VM600 racks employing this type of
card (that is, networked racks).
Unless otherwise specified at the time of ordering, each CPUM card is given the IP address
of 10.10.56.56 in the factory before delivery of the system. However, it is strongly
recommended to change this IP address, which can be done using the CPUM Configurator
software or a terminal emulator program.
NOTE: Refer to the VM600 networking manual for further information.
To Next Page
Loading...
