Document reference MAMPS-HW/E HARDWARE MANUAL
Edition 18 - March 2022 VM600 machinery protection system (MPS)
11 - 1
Definition of screw terminals on the RLC16 card
USING THE RLC16 CARD
11 USING THE RLC16 CARD
This chapter describes the connectors on the RLC16 card. These are accessed from the rear
of a VM600 MPS rack.
11.1Definition of screw terminals on the RLC16 card
The RLC16 panel (rear of rack) contains three terminal strips, identified as J1, J2 and J3 (see
Figure 11-1). Each strip consists of a socket and a mating connector, which contains 16
screw terminals. The screw terminals can accept wires with a cross-section of ≤1.5 mm
2
.
Each socket and mating connector can be equipped with a mechanical key system to prevent
incorrect connection.
Further details on these screw terminal contacts can be found in Table 11-1.
To Next Page
Loading...
Need help?
General