Document reference MAMPS-HW/E HARDWARE MANUAL
Edition 18 - March 2022 VM600 machinery protection system (MPS)
C-1
DEFINITION OF BACKPLANE CONNECTOR PINS
APPENDIX C: DEFINITION OF BACKPLANE
CONNECTOR PINS
This appendix defines the pins on backplane connectors P1, P2, P3 and P4.
The definition of pins on each connector depends on the position of the connector on the rack
backplane (that is, in which slot it is used). The information is presented in tabular form for
the following groups of slots:
• Slot 0 (see Figure C-1)
• Slots 1 and 2 (see Figure C-2)
• Slots 3 to 14 (see Figure C-3)
• Slots 15 and 18 (see Figure C-4).
To Next Page
Loading...