Meggitt vibro-meter VM600 User Manual

HARDWARE MANUAL Document reference MAMPS-HW/E
VM600 machinery protection system (MPS) Edition 18 - March 2022
9-54
Assigning alarm signals to relays on the RLC16 card
CONFIGURATION OF MPC4 / IOC4T CARDS
13
12 - - - - - - J61 J94 J93 - - -
- - - 38 J312 J62 J94 J93 6 High
- - - 46 J328 J63 J94 J93 14 High
- - - 54 J344 J64 J94 J93 22 High
- - - 62 J360 J65 J94 J93 30 High
14
13 - - - - - - J66 J114 J113 - - -
- - - 6 J313 J67 J114 J113 6 Low
- - - 14 J329 J68 J114 J113 14 Low
- - - 22 J345 J69 J114 J113 22 Low
- - - 30 J361 J70 J114 J113 30 Low
15
14 - - - - - - J71 J96 J95 - - -
- - - 39 J314 J72 J96 J95 7 High
- - - 47 J330 J73 J96 J95 15 High
- - - 55 J346 J74 J96 J95 23 High
- - - 63 J362 J75 J96 J95 31 High
16
15 - - - - - - J76 J116 J115 - - -
- - - 7 J315 J77 J116 J115 7 Low
- - - 15 J331 J78 J116 J115 15 Low
- - - 23 J347 J79 J116 J115 23 Low
- - - 31 J363 J80 J116 J115 31 Low
Notes
1. To attribute a Raw Bus line to a relay, the appropriate jumper must have contacts 1-2 closed.
2. To obtain a raw signal on a Raw Bus line, the appropriate jumper(s) must have contacts 1-3 closed. For differential signals,
two jumpers must be set. For example, for Raw Bus line 16, set J332 and J333 as they correspond to 16 High and 16 Low
respectively.
Table 9-7: Jumpers and bus lines associated with relays on the RLC16 card (continued)
Line number Jumper settings
Relay
number
(on RLC16)
OC
Bus
Raw
Bus
On IOC4T
(see note 1 and
note 2)
On RLC16 Raw Bus
signal line
used
(see note 2)
To select the
relay
To set the
relay as NE
To set the
relay as NDE

Meggitt vibro-meter VM600 Specifications

General

Brand	Meggitt
Model	vibro-meter VM600
Category	Protection Device
Language	English