Meggitt vibro-meter VM600 User Manual

Document reference MAMPS-HW/E HARDWARE MANUAL
Edition 18 - March 2022 VM600 machinery protection system (MPS)
10 - 27
Assigning alarm signals to relays on the RLC16 card
CONFIGURATION OF AMC8 / IOC8T CARDS
13
12 - - - - - - J61 J94 J93 - - -
- - - 38 J112 J62 J94 J93 6 High
- - - 46 J128 J63 J94 J93 14 High
- - - 54 J144 J64 J94 J93 22 High
- - - 62 J160 J65 J94 J93 30 High
14
13 - - - - - - J66 J114 J113 - - -
- - - 6 J113 J67 J114 J113 6 Low
- - - 14 J129 J68 J114 J113 14 Low
- - - 22 J145 J69 J114 J113 22 Low
- - - 30 J161 J70 J114 J113 30 Low
15
14 - - - - - - J71 J96 J95 - - -
- - - 39 J114 J72 J96 J95 7 High
- - - 47 J130 J73 J96 J95 15 High
- - - 55 J146 J74 J96 J95 23 High
- - - 63 J162 J75 J96 J95 31 High
16
15 - - - - - - J76 J116 J115 - - -
- - - 7 J115 J77 J116 J115 7 Low
- - - 15 J131 J78 J116 J115 15 Low
- - - 23 J147 J79 J116 J115 23 Low
- - - 31 J163 J80 J116 J115 31 Low
Notes
1. To attribute a Raw Bus line to a relay, the appropriate jumper must have contacts 1-2 closed.
Table 10-2: Jumpers and bus lines associated with relays on RLC16 card (continued)
Line number Jumper settings
Relay
number (on
RLC16)
OC
Bus
Raw
Bus
On IOC8T
(see note 1)
On RLC16
Raw Bus
signal line
used
To select the
relay
To set the
relay NE
To set the
relay NDE

Meggitt vibro-meter VM600 Specifications

General

Brand	Meggitt
Model	vibro-meter VM600
Category	Protection Device
Language	English