EasyManuals Logo

Mercury 75 Service Manual

Mercury 75
574 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #346 background imageLoading...
Page #346 background image
5B-28 - MID-SECTION 90-830234R3 DECEMBER 1997
4. Remove reservoir from manifold.
a
b
53960
a - Reservoir
b - Oil Pump
Manifold Removal
1. Remove screws and manifold from cylinder.
a
b
c
53962
a - Trim Cylinder
b - Manifold
c - Screw (2)
2. Remove check valve components from manifold.
IMPORTANT: Sleeve (f) is chamfered on I.D. on
end opposite drilled cross hole. Install spool (g)
(with O-ring installed) from chamfered end of
sleeve to avoid possibility of damaging O-ring on
spool.
a
b
b
c
d
d
d
e
f
g
h
53961
a - Manifold and Pump
b - Spring (2)
c - Check Valve
d - O-ring (4)
e - Seat
f - Sleeve
g - Spool
h - Chamfered End
3. Remove O-rings from cylinder.
a
51008
a - O-rings

Table of Contents

Other manuals for Mercury 75

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mercury 75 and is the answer not in the manual?

Mercury 75 Specifications

General IconGeneral
Horsepower75 hp
StartingElectric
Cylinders3
Warranty3 years
Shaft Length20 in. or 25 in.

Related product manuals