EasyManua.ls Logo

MERLO PANORAMIC - End of Section

MERLO PANORAMIC
200 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
6 - ORDINARY MAINTENANCE
6 - 35
MALFUNCTIONING OF THE EMERGENCY PUMP TO DISENGAGE THE
PARKING BRAKE
If it is not possible to release the parking brake using the emergency pump, act
as follows (see paragraph "TOWING OF THE MACHINE" in the section
"OPERATING INSTRUCTIONS"):
- chock the wheels to lock the machine in place
- hold the brake calliper chamber (A) still
- fully loosen the adjusting screw (B)
Before restarting the vehicle tighten the adjusting screw and make sure the
system is working correctly.
• "EMERGENCY" FUNCTION
(only for models with DEUTZ engine)
Using the "EMERGENCY" function, in the
event of an electronic fault with the
hydrostatic transmission (for example the
machine does not move either forwards or
backwards), it is possible to reset the
movements at about 40% of the maximum
speed.
Rotating the ignition key "8" to "R" the
luminous selector "A" flashes; when the
engine starts it switches off.
Activating the system:
- Luminous selector (A) on "0" = emergency function disengaged (the selector is off)
- Indicator light selector (A) on "1" = emergency function engaged (the selector is ON).
WARNING!
Never remove the cover of the box, this should only and exclusively be carried out by personnel from the technical
assistance service of MERLO S.p.A.
END OF SECTION

Table of Contents