4 - COMMANDS AND INSTRUMENTS
4 - 15
• CROSSWAYS TILT CORRECTOR COMMAND (61)
ROCKER SWITCH (61)
A = clockwise chassis levelling
B = anticlockwise chassis levelling
WARNING!
Make sure that machine is correctly levelled before attempting any lifting
operations.
Load handling on uneven surfaces is permitted by using frame levelling
device to level the machine chassis to the proper position. Check correct
levelling using the spirit level in the cab.
If the machine boom is raised beyond the safety limit, operating the
crossways tilt corrector is prevented by a specific device.
DESCRIPTION OF THE COMMAND PANEL (P1)
• HEATING (35)
COCK (REF. 35)
A = maximum temperature
C = minimum temperature
CAB FAN SWITCH (REF. 36)
0 fan OFF
1 fan activated at first speed
2 fan activated at second speed
WARNING! Do not leave any objects behind the seat as they could
obstruct the ventilation system air inlet.
SELECTION OF THE AIR SUCTION FROM INSIDE/OUTSIDE THE CAB
To select the air suction mode, use the relevant reference control "R" located
behind the seat, as follows:
- lever in position "A" (air intake grill "C" not visible): air suction from the
outside of the cab
- lever in position "B" (air intake grill "C" visible): air suction from the inside of the cab (recirculation)
To Next Page
Loading...