8 - ATTACHMENTS AND OPTIONAL EXTRA
1 - 29
JOYSTICK (5 FUNCTIONS)
5 main movements can be performed with this joystick (2 movements controlled
by the lever of the joystick and 3 movements controlled by wheels R1, R2 and
R3).:
1) LIFTING/LOWER OF THE TELESCOPIC BOOM
2) UPWARD/DOWNWARD ROTATION OF THE FORKS
3) EXTENSION/RETRACTION OF THE TELESCOPIC BOOM
4) COMMAND FOR ATTACHMENTS INSTALLED ON THE CARRIAGE (AUX)
5) COMMAND FOR ATTACHMENTS INSTALLED ON THE CARRIAGE (AUX 1)
Press and hold button "U" to enable the joystick (1) commands.
The first two movements are carried out by moving the joystick in the longitudinal
and transverse direction, while the remaining three movements are performed
using the control wheels "R1", "R2" and "R3". The speed of the movement to be
made is proportional to:
- the inclination given to the control joystick (the greater the movement of the
joystick, the greater the speed of the movement)
- the rotation of the control wheels "R1", "R2" and "R3" (the greater the
rotation, the greater the speed of the movement)
- the rpm of the diesel engine (the higher the rpm of the engine, the greater the
speed of movement).
The movement stops automatically when the joystick or related wheel is
released. Depending on load conditions, it is possible to combine movements.
• JOYSTICK LEVER (1) IN POSITION:
A = boom lifting
B = boom descent
C = tilting of forks downward
D = tilting of forks upward
- CONTROL WHEEL "R1"
1 = extension of the telescopic boom
2 = retraction of the telescopic boom
- CONTROL WHEEL "R2" (AUX)
3 = attachments release/attachments command
4 = attachments command
- CONTROL WHEEL "R3" (AUX 1)
5 = attachments command
6 = attachments command
WARNING! Before operating the machine, please mark off the area where the machine needs to be operated, in
order to keep both people and vehicles away from it.
Should you need to operate the machine near overhead lines, the person in charge of safety shall require the
minimum safety distance from such lines to the manager of said lines, as well as from the authorities in charge of
safety and health in the workplace; in this way all necessary precautions shall be taken and potential accidents shall
be prevented. For further information please refer to paragraph "INSTRUCTIONS FOR A CORRECT USE OF THE
MACHINE NEAR OVERHEAD LINES" in chapter "OPERATING INSTRUCTIONS".
- ELECTRICAL CONNECTION OF DUAL-FUNCTION ACCESSORIES
Move the plug from socket "A" to support socket "B". The dual-function attachments are equipped with an electric cable which
must be connected to the electrical outlet "A" on the head of the boom.
To Next Page
Loading...