MERLO PANORAMIC - ATTACHMENTS COMPATIBLE with VEHICLES MANUFACTURED by MERLO S.p.a

8 - ATTACHMENTS AND OPTIONAL EXTRA
8 - 6
WARNING! Keep people away from the surrounding area when uninstalling equipment. Consult the data plates
inside the driver's cab so that the machine's load limits in relation to the various positions of the boom are not
exceeded.
Never force the attachment on to the ground to carry out uncoupling.
ATTACHMENTS COMPATIBLE WITH VEHICLES MANUFACTURED BY MERLO S.p.A.
The attachments described in this paragraph are those available at the time the manual was published. For increased safety,
before using any type of attachment, always check all of the relevant data given in the type-approval charts applied to the
attachment.
• EXTRA LARGE FORK CARRIAGE
To install this attachment on the carriage, carry out the same operations
described in paragraph "INSTALLATION OF QUICK-COUPLING
ATTACHMENTS" in this chapter.
Install this attachment on the carriage if you need a larger distance between the
forks.
The installation of this attachment on the carriage implies the following reduction
of the load capacity shown in the load chart:
- Liftable load (W) with an extra large fork carriage = machine load chart "D" -
attachment weight "P" shown on the attachment identification plate.
• FEM III FORK CARRIAGE
To install this attachment on the carriage, carry out the same operations
described in paragraph "INSTALLATION OF QUICK-COUPLING
ATTACHMENTS" in this chapter.
Install this attachment on the carriage if you need to use FEM III FORKS.
The installation of this attachment on the carriage implies the following reduction
of the load capacity shown in the load chart:
- Liftable load (W) with FEM III fork carriage = machine load chart "D" -
attachment weight "P" shown on the attachment identification plate.
• TRAVELLING LIFT FITTED ON A STANDARD CARRIAGE
To install this attachment on the carriage, carry out the same operations
described in paragraph "INSTALLATION OF QUICK-COUPLING
ATTACHMENTS" in this chapter.
The attachment is comprised of a fixed part, coupled to the standard carriage,
and a mobile part, which shifts the load lifted on the FEM III FORKS transversely
with respect to the telescopic boom of your machine.
The installation of this attachment on the carriage implies the following reduction
of the load capacity shown in the load chart:
- Liftable load (W) with a travelling lift fitted on the standard carriage = machine
load chart "D" - attachment weight "P" shown on the attachment identification
plate.