1 - INTRODUCTION
1 - 5
WARRANTY
To benefit from the Manufacturer's warranty, the operator shall take all the precautions described in the Operator's Manual, with
particular reference to the following:
- comply with the operating limits defined by the Manufacturer
- never make any changes to the machine without prior written authorization from the Manufacturer
- always carry out all the maintenance operations prescribed by the Manufacturer
- always use Merlo original spare parts
- make sure that the personnel operating the vehicle have the necessary skills and are properly trained.
The Manufacturer's warranty shall not apply if the conditions above are not met, or are only partially met.
If spare parts which are not approved by the Manufacturer are used, any warranty shall be made void and the Manufacturer
shall be exempt from any liability for malfunctions or accidents.
The removal or modification of safety guards exonerates the Manufacturer from any liability for damage caused to property
and/or persons.
ORDINARY MAINTENANCE OPERATIONS
In order to ensure that the machine is used in maximum safety, reliability and efficiency conditions, it is key to regularly carry
out all ordinary maintenance operations following closely the instructions provided by the present operator manual.
Do not use the machine unless all maintenance operations and any necessary repair work have been executed.
Should the operator notice that the machine does not operate as it should or it does not meet all safety requirements, the
anomaly shall be immediately communicated to the person in charge.
Before carrying out any work on the machine, the engine must be stopped, the travel direction selector must be brought to its
central position and the gear selector must be in neutral gear.
Maintenance operations must be carried out by qualified and skilled staff. For any work on parts which fall outside the scope of
ordinary maintenance operations - as defined by the present operator manual - contact the Merlo Technical Support Service.
It is strictly forbidden and highly dangerous to modify any machine component by changing its original structure. it is further
forbidden to change the hydraulic and electric setup or modify the safety systems. Otherwise, Merlo S.p.A shall be relieved
from any civil or criminal liability.
INFORMATION FOR DRIVING THE MACHINE ON PUBLIC ROADS
For all information on how to drive the machine on public roads, always refer to the applicable laws of the country where the
machine is used.
To Next Page
Loading...