3 - STICKERS WITH CONTROL DESCRIPTIONS - LEAFLETS IN THE CAB
3 - 2
GENERAL REMARKS
All the stickers and the leaflets described in this chapter shall always be available on your machine; for this reason, make sure
that they are undamaged, and clean them periodically with a cloth dampened with a mild soap and water solution.
Should they be damaged or illegible, replace them with new original ones, to be ordered from Merlo Technical Support Service,
and to be placed in the positions shown in the Operator's Manual.
Most of the symbols used are based on the International ISO 3287 and ISO 6405 standards. In any case, to avoid any
misinterpretation, do not use the controls before having looked up the pertaining information contained in section "CONTROLS
AND INSTRUMENTS".
INSIDE CAB STICKERS
(only for models P37.12PLUS – P38.12PLUS – P38.13PLUS – P38.14PLUS – P40.9PLUS – P40.17PLUS – P60.10 – P72.10)
To Next Page
Loading...