MERLO PANORAMIC - Page 143

7 - PERIODIC SAFETY INSPECTIONS
7 - 5
(P40.17 – P40.17PLUS – P40.17EE)
TYPE OF MACHINE CHASSIS NUMBER NAME OF CONTROLLER
FUNCTION TO BE CHECKED
PERIOD IN HOURS / MONTHS
Every
250 hours or 2 months
Every
500 hours or 6 months
Every
1000 hours or 1 year
Control
Date
Restoration
Date
Control
Date
Restoration
Date
Control
Date
Restoration
Date
Functioning of the anti-overturn system
acoustic alarm
.../.../... .../.../... .../.../... .../.../... .../.../... .../.../...
Functioning of the anti-overturn system
visual alarm
.../.../... .../.../... .../.../... .../.../... .../.../... .../.../...
Functioning of the anti-overturn system
movement locking
.../.../... .../.../... .../.../... .../.../... .../.../... .../.../...
Check the stabiliser and levelling control
distributor locking system with the boom
raised
.../.../... .../.../... .../.../... .../.../... .../.../... .../.../...
Make sure that the operating and
maintenance instruction manual is in the cab
.../.../... .../.../... .../.../... .../.../... .../.../... .../.../...
Check spirit level calibration .../.../... .../.../... .../.../... .../.../... .../.../... .../.../...
Check the maximum pressure in the
oleodynamic system
.../.../... .../.../... .../.../... .../.../...
Check the jack locking valves .../.../... .../.../... .../.../... .../.../...
Check the parking brake .../.../... .../.../... .../.../... .../.../...
Check of the three steering operating modes .../.../... .../.../... .../.../... .../.../...
Check the power steering unit calibration
pressure
.../.../... .../.../... .../.../... .../.../...
Control of the attachment points and the
adjustment of the boom extension chains
.../.../... .../.../... .../.../... .../.../...
Check, inside the cab and on the machine,
for the presence and condition of the
instruction plates
.../.../... .../.../...
Signature: Machine total working hours:
WARNING!
Before beginning any of the checking operations (described below) which require machine movement, make sure
there are no people or objects in its radius of operation. Furthermore, for operations which require a load to be lifted,
ensure that the machine is on a compact surface and is fully level.
Should any anomalies be identified during these checks, do not use the machine before they have been resolved.