5 - OPERATING INSTRUCTIONS
5 - 7
• GENERAL CHECKS BEFORE STARTING THE ENGINE
NOTE! A P40.17PLUS was taken to list the parts to be checked. The same instructions apply to all models
included in this manual.
Carry out the following checks every day (before using the vehicle):
- keep all machine parts in due order and clean
- inspect the exterior of the machine to check that no screws or bolts are loose or missing and that there are no leakages of
hydraulic oil
- roof rotating flashing beacon (figure 1)
- water level in the radiator (figure 2)
- hydrostatic transmission oil level (figure 3)
- tyre pressure and condition (figure 4)
- presence, function and good condition of the safety belt (figure 5)
- adjust the seat to ensure that all the driver controls can be conveniently reached
- adjust the rear view mirrors to ensure good visibility from the driver's seat
- check the correct opening and closing of the upper and lower part of the driver's cab door
To Next Page
Loading...