Quadra-Chek
®
QC200
7-13
Step 7
Highlight the scale counts (scale cnts) field as shown.
Step 8
Press the teach soft key.
NOTENOTE
NOTENOTE
NOTE
Press the reset soft key to set the scale counts (scale cnts) fieldsPress the reset soft key to set the scale counts (scale cnts) fields
Press the reset soft key to set the scale counts (scale cnts) fieldsPress the reset soft key to set the scale counts (scale cnts) fields
Press the reset soft key to set the scale counts (scale cnts) fields
to zero. It is not necessary to press the reset soft key if the scaleto zero. It is not necessary to press the reset soft key if the scale
to zero. It is not necessary to press the reset soft key if the scaleto zero. It is not necessary to press the reset soft key if the scale
to zero. It is not necessary to press the reset soft key if the scale
counts field reads zero.counts field reads zero.
counts field reads zero.counts field reads zero.
counts field reads zero.
Step 9
Rotate the Q axis 180 degrees.
NOTENOTE
NOTENOTE
NOTE
This example uses a teach amount of 180 degrees. Rotate the QThis example uses a teach amount of 180 degrees. Rotate the Q
This example uses a teach amount of 180 degrees. Rotate the QThis example uses a teach amount of 180 degrees. Rotate the Q
This example uses a teach amount of 180 degrees. Rotate the Q
axis by the amount entered in the teach amount field.axis by the amount entered in the teach amount field.
axis by the amount entered in the teach amount field.axis by the amount entered in the teach amount field.
axis by the amount entered in the teach amount field.
To Next Page
