Quadra-Chek
®
QC200
3-39
Measuring lines
The QC200 allows the user to probe up to 100 points while measuring a line. A
minimum of two points are required to measure a line. Use more points for
greater accuracy. A best-fit algorithm is applied to lines with more than two
points to determine location. The resulting F (Form) value is included in the
feature data.
TT
TT
T
o measure a lineo measure a line
o measure a lineo measure a line
o measure a line
Step 1
Press the line key.
NOTENOTE
NOTENOTE
NOTE
Press the Press the
Press the Press the
Press the
line keyline key
line keyline key
line key
twice to measure a series of lines using twice to measure a series of lines using
twice to measure a series of lines using twice to measure a series of lines using
twice to measure a series of lines using
autoauto
autoauto
auto
repeatrepeat
repeatrepeat
repeat
..
..
.
Step 2
Probe the first point as shown.
Step 3
Press the enter key.
Step 4
Probe two more points along the line. Press the enter key after each point.
To Next Page
Loading...
