Micsig TO1102 - Default Chapter; Table of Contents

Table of Contents
i
Table of Contents
TABLE OF CONTENTS ................................................................................................................................................ I
CHAPTER 1. SAFETY PRECAUTIONS ......................................................................................................................... 4
1.1 SAFETY PRECAUTIONS........................................................................................................................................... 4
1.2 SAFETY TERMS AND SYMBOLS .............................................................................................................................. 5
CHAPTER 2. QUICK START GUIDE OF OSCILLOSCOPE ............................................................................................... 7
2.1 INSPECT PACKAGE CONTENTS ............................................................................................................................... 8
2.2 USE THE BRACKET ................................................................................................................................................ 8
2.3 REAR PANEL & SIDE PANEL .................................................................................................................................... 9
2.4 FRONT PANEL ........................................................................................................................................................ 9
2.5 POWER ON/OFF THE OSCILLOSCOPE ..................................................................................................................... 10
2.6 UNDERSTAND THE OSCILLOSCOPE DISPLAY INTERFACE ...................................................................................... 11
2.7 INTRODUCTION BASIC OPERATIONS OF TOUCH SCREEN ...................................................................................... 12
2.8 MOUSE OPERATION ............................................................................................................................................. 14
2.9 CONNECT PROBE TO THE OSCILLOSCOPE ............................................................................................................. 14
2.10 USE AUTO ......................................................................................................................................................... 15
2.11 LOAD FACTORY SETTINGS ................................................................................................................................. 17
2.12 USE AUTO-CALIBRATION ................................................................................................................................... 17
2.13 PASSIVE PROBE COMPENSATION ....................................................................................................................... 17
2.15 MODIFY THE LANGUAGE ................................................................................................................................... 19
CHAPTER 3 HORIZONTAL SYSTEM.......................................................................................................................... 20
3.1 MOVE THE WAVEFORM HORIZONTALLY .............................................................................................................. 21
3.2 ADJUST THE HORIZONTAL TIME BASE (TIME/DIV) ............................................................................................... 21
3.3 PAN AND ZOOM SINGLE OR STOPPED ACQUISITIONS ........................................................................................... 23
3.4 ROLL, XY ............................................................................................................................................................ 23
3.5 ZOOM MODE ....................................................................................................................................................... 26
CHAPTER 4 VERTICAL SYSTEM ............................................................................................................................... 29
4.1 OPEN/CLOSE WAVEFORM (CHANNEL, MATH, REFERENCE WAVEFORMS) ........................................................... 30
4.2 ADJUST VERTICAL SENSITIVITY .......................................................................................................................... 32
4.3 ADJUST VERTICAL POSITION ............................................................................................................................... 32
4.4 OPEN CHANNEL MENU ........................................................................................................................................ 33
4.4.1 Set Channel Coupling ................................................................................................................................... 33
4.4.2 Set Bandwidth Limit .................................................................................................................................... 35
4.4.3 Waveform Inversion .................................................................................................................................... 36
4.4.4 Set Probe Type ............................................................................................................................................. 37
4.4.5 Set Probe Attenuation Coefficient ............................................................................................................... 38
CHAPTER 5 TRIGGER SYSTEM ................................................................................................................................ 39
5.1 TRIGGER AND TRIGGER ADJUSTMENT ................................................................................................................. 40