Filling the container for dishwasher salt
28
Salt refill indicator
If the level in the salt container is low and a
reactivation is carried out, the following
message appears on the display:
Refill salt -appliance will be disabled
shortly.
Confirm the message with OK.
Fill the salt container as described.
If the message is being displayed for the
first time, further programme runs may be
possible depending on the set water
hardness. If no salt is added, the message
is displayed again at the end of every
programme.
Reactivation notification
Approx. wash cycles left until
reactivation.
You can set how many cleaning cycles in
advance you want to be notified of the
upcoming reactivation, see “Extended
settings”, “Reactivation notification”.
Machine blocked if salt is not
available
If the salt in the water softener has been
used up, a fault appears on the display and
the machine blocked from performing
further applications.
Acknowledge the fault by tapping on the
warning symbol. Then follow the
instructions on the display:
F561 Machine blocked insufficient salt:
refill dishwasher salt. Machine will
unlock after a few seconds. Then start
the “Cold” programme.
Fill the salt container as described.
The machine lock is lifted with a delay of a
few minutes once salt has been added.
To Next Page
Loading...
Need help?
General
