Cleaning agent and rinsing agent
31
Power supply connection for DOS1,
cleaning agent (depending on the model).
Power supply connection for DOS4,
rinsing agent.
Connections for dispensing hoses.
Damage caused by incorrect voltage.
Before fitting the dispensing module,
compare the connection data (voltage
and frequency) on the module data plate
with that on the data plate of your
dishwasher. If the data does not match,
the module could sustain damage.
If in any doubt, consult a qualified
electrician.
Connect the module to the machine’s
power supply.
To connect the dispensing hoses, release
the hose clip on a free connector and
remove the safety cap.
Push the dispensing hose onto the
connector and secure it with a hose clip.
Blank off unused connectors for
dispensing hoses with safety caps to
prevent the leakage of wash water.
Cleaning agent
Only use cleaning agent suitable for
commercial dishwashers.
Suitable products are available from the
Miele Professional product range.
Cleaning agent can be dispensed in powder
form, as a tablet or in liquid form.
Powder cleaning agent and tablets are
dispensed via the door dispenser with the
symbol.
Only use cleaning agent tablets that are
quick dissolving. Suitable tablets are
available from the Miele Professional
product range.
Filling the door dispenser
Risk to health due to dust production.
When dispensing powder cleaning agents
and tablets, dust from fine cleaning
agents can be stirred up. If this dust gets
into the mouth, throat or eyes, it can
cause irritation or burns.
When dispensing powder cleaning agents
and tablets, avoid the production of dust
as much as possible.
Add powder cleaning agent or a tablet to
the powder cleaning agent dispenser before
every wash programme (except Super Short,
Cold, Reactivation and Drain). Follow the tips
on the Super Short programme.
Press the yellow button on the dispenser
container with the symbol.
The flap will spring open. The flap is always
open at the end of a programme run.
To Next Page
Loading...
