Miele PFD 402 - Final Rinse Temperature; Final Rinse Holding Time; Increased Water Level

Further settings
64
Final rinse temperature
The final rinse temperature is reached by
heating up the wash water. The temperature
needs to be adjusted to the task.
This menu option is not available on
dishwashers with Dry+ drying.

OK
08:15
78
79
80
°C
81
82
Final rinse temperature
 Set the temperature. The adjustment
range varies depending on the model and
programme.
 Press OK to save the setting
Final rinse holding time
The holding time is a period during which
the temperature in the wash block is kept
constant.
In the case of the Super Short
programme, the holding time is entered in
seconds and can be adjusted in 5-second
increments.

OK
08:15
Final rinse holding time
10
9
8
min
7
6
 Set the holding time.
 Press OK to save the setting
Increased water level
It is then advisable to increase the water
level when a lot of water is absorbed due to
the structure of the load items or when the
type of soiling and the process chemicals
used lead to excess foam development. The
additional volume of water depends on the
type of basket or mobile unit used, the type
of soiling and the load items.
If slightly soiled load items which absorb a
little water are being reprocessed, the water
level can be reset to the factory default
setting to save water and energy.

OK
08:15
2,0
1,5
1,0
0,5
0,0
Increas. water quantity
l
 Set the additional volume of water. In the
lowest setting, the volume of water
corresponds to the factory default setting.
 Press OK to save the setting.