Problem solving guide
86
Door
Problem Cause and remedy
The door opens again after
being closed
If the door is closed with too much force, the comfort door
locking mechanism will open it again.
Guide the door into the door lock with less force.
Hot wash cabinet: Risk of in-
jury, take care when opening
the door.
The temperature in the wash cabinet is over 67°C when
the button is pressed.
When the door is opened, hot steam and process
chemicals can escape!
Open the door only when strictly necessary.
The door is open a fraction
and cannot be closed us-
ing the button.
This is not a fault.
The Comfort door lock has opened the door slightly at the
end of the programme.
Open the door. The door can now be closed completely
again using the button.
F433 Door blocked: Remove
blockage in door area. Turn
appliance off and on.
A protruding load item is obstructing the door.
Arrange the load item so that it does not obstruct the
door.
Close the door.
The comfort door lock is blocked.
Try to open the door carefully (without using force) by
pulling on the door handle.
If the door is still blocked:
Open the door using the emergency release.
Close the door and try to open it again using the
button.
If it is still blocked:
Contact the Miele Customer Service Department.
Anti-trap guard: To continue,
open door.
This is not a fault!
The door is locked while the door locking mechanism
retracts to the lock position.
Open the door and wait until the door locking
mechanism reaches its final position.
To Next Page
Loading...
