Miele PFD 402 - Dispensing Concentration; Filling Dispensing Paths; Rinsing Dispensing Paths; Cycles until Empty

Further settings
69
Dispensing concentration
The dispensing concentration for liquid
process chemicals is set in the same way
for all dispensing systems. The setting
applies to all programmes.
This selection is only available if the
corresponding dispensing system is
present (depending on the model).
Rinse aid door
Clean. agent canister
Rinse aid canister
 Start by selecting a dispensing system.

OK
08:15
0,05
0,04
Dispens. concentration
0,03
0,02
0,01
%
 Set the dispensing concentration.
 Press OK to save the setting.
Filling dispensing paths
See Machine functions
Rinsing dispensing paths
See Machine functions
Cycles until empty
When dispensing liquid process chemicals
from external canisters, the fill level in the
canister is monitored. You can use the
following function to set the number of
programme sequences (cycles) from which
you want to be warned about the
imminently empty canisters. The message is
displayed after switching on the machine
and before every programme start.
You can set the number of cycles from 0–
150cycles; at 0, a notification is only issued
when the canisters are empty.

OK
08:15
50
40
30
20
10
Cycles until empty
 Set the number of cycles.
 Press OK to save the setting.
Water hardness
The water hardness setting is described in
“Filling the salt container”.