Miele PFD 402 - Refill Indicator; Replacing the Canister

Cleaning agent and rinsing agent
35
 Close the container.
 Wipe up any spilled rinsing agent
thoroughly. This prevents over-foaming
during the next programme.
Alternatively, you can start the
Coldprogramme to rinse off any spilled
rinsing agent.
Refill indicator
When the fill level in the rinsing agent
container is low, you are reminded to
change the canister, e.g.:

OK
Change rinse aid canister. Empty
status detected.
 Confirm the prompt with OK and change
the rinsing agent canister as described.
 Fill the dispensing path (see “Machine
functions”)
Replacing the canister
 Place the rinsing agent container (note the
colour marking) on the open wash cabinet
door or on a surface which is robust and
easy to clean.
 Take the lid off the canister and remove
the suction lance. Place the suction lance
on the open wash cabinet door.
 Replace the empty container with a full
one.
 Push the suction lance into the opening of
the container and secure the lid. Observe
the colour coding.
 Feed the suction lance into the container
until it reaches the bottom.
 Wipe up any spilled process chemical
thoroughly.