Miele PFD 402 - Problem Solving Guide; Technical Problems

Problem solving guide
82
With the aid of the following guide, most minor problems that can occur during daily
operation can be corrected without contacting Miele. You can save time and money in
many cases, as you do not need to call the Miele Customer Service Department.
The following guide should help you to find the reason for a malfunction or fault and to
correct it. You should, however, note the following:
 Danger due to incorrect repairs.
Incorrect repairs can cause considerable danger to users.
Repairs must only be carried out by the Miele Customer Service Department, an
authorised Miele dealer or a suitably qualified specialist.
Technical problems
Problem Cause and remedy
The display remains dark
and the Start/Stop display
light is not flashing after
the dishwasher has been
switched on with the
button.
The machine is not plugged in.
 Insert the plug and switch on at the socket.
The circuit breaker has tripped.
 Reset the trip switch in the circuit breaker box
(see data plate for minimum protection rating).
The dishwasher stops dur-
ing a programme
The circuit breaker has tripped.
 Reset the trip switch in the circuit breaker box (see data
plate for minimum protection rating).
 If the circuit breaker trips again, contact the Miele
Customer Service Department.
Power failure during oper-
ation
If a temporary power failure occurs during a programme
sequence, no measures are required.
The programme will continue after the interruption.
If the temperature in the wash cabinet drops below the
minimum value required for the programme block during
the power failure, the programme block is repeated.