Cleaning and care
80
Cleaning the flat and micro-fine filters
Remove the coarse filter as described
before.
Grasp the micro-fine filter by the upper rim
and turn it in the direction of the arrow to
release it.
Then lift it out.
Remove the flat filter.
Rinse the filters under running water. If
necessary, use a soft washing-up brush to
remove soiling.
Replace the filter combination in the reverse
order, turning the micro-fine filter to the left
to re-engage it.
The flat filter must lie flat in the bottom of
the wash cabinet.
The spray arms may get blocked if the
filters are not replaced correctly.
Ensure that the filters are positioned
correctly.
Cleaning the spray arms
The dishwasher has three different spray
arms.
Particles of food can get stuck in the spray
arm nozzles and bearings. The spray arms
should therefore be checked and cleaned
regularly.
Switch the dishwasher off.
Pull the upper spray arm downwards to
remove it.
The middle and bottom spray arms are
secured with a bayonet fitting.
The bayonet fitting on the lower spray arm
is coloured yellow so that it cannot be
mistaken for the fitting on the middle spray
arm.
To release the bayonet fitting, proceed as
follows:
Using the knurled nut, turn the middle
spray arm to the left as far as it will go
and then pull the spray arm downwards to
remove it.
Remove the lower basket.
Using the knurled nut, turn the lower
spray arm in the direction of the arrow as
far as it will go and then pull the spray arm
upwards to remove it.
To Next Page
Loading...
