Problem solving guide
88
Problem Cause and remedy
Water remains in the wash
cabinet at the end of a
programme.
(This does not apply to the
Super short programme)
Before rectifying the problem:
Switch the dishwasher off with the button.
The filter combination in the wash cabinet is clogged.
Clean the filter combination (see “Cleaning and care”).
The drain pump or the non-return valve is blocked.
Clean the drain pump or the non-return valve (see
“Problem solving guide”).
The drain hose is kinked.
Remove any kinks from the drain hose.
The on-site drain siphon is blocked.
Check and clean the drain siphon.
Peak-load negotiation: heat-
ing mode temporarily dis-
abled.
This is not a fault!
Your energy management system has detected a peak
load in the energy supply. Some components in the
dishwasher stop operating for the duration of the peak-
load negotiation.
Cycles until empty
This is not a fault!
The level of process chemicals has reached the value
specified for the remaining wash cycles and this is
indicated on the display.
Temperature compensation
after opened door: Pro-
gramme will continue in min
This is not a fault!
If the door is opened during a programme sequence and
the temperature in the wash cabinet is above 60°C,
pressure equalisation takes place once the door is closed.
To Next Page
Loading...
