Milli-Q Direct 8 - Installing the Q-Pak Pack

Milli-Q® Direct 8/16 System 29
Installing the Q-Pak® Pack
Procedure
Follow the steps below to install a new Q-Pak® Pack.
Step
Action
Diagram
1
Start in STANDBY Mode.
2
•
Open the left door of the
System.
• Remove the 2 protective caps
located on the ports inside.
3
•
Remove the covers on the
2 ports of the Q-Pak® Pack.
• Make sure the rubber O-rings
are firmly in place.
• Wet the O-rings with water.
4
Push the top of the Q-Pak® Pack
into the ports on the
System.
Continued on next page