Milli-Q Direct 8 - Replacing the Q-Pak Pack

78 Milli-Q® Direct 8/16 System
Replacing the Q-Pak® Pack
When
The Q-Pak® Pack should be replaced when one of the following Alarm or Alert messages
is displayed.
• Alarm message = MILLI-Q RES < SP, REPLACE Q-PAK
•
Alert message = REPLACE Q-PAK PACK
Removing
Remove the used Q-Pak® Pack by following the steps below.
Step
Action
Diagram
1
Place the system into STANDBY
Mode.
2
Push the POD Plunger down
once to depressurise the System.
After water stops being
dispensed, push down the
POD Plunger again.
3
Open the System left door.
Lift up the Pack Locking Handle.
Continued on next page