Milli-Q Direct 8 - Initial Setup and Calibration

Milli-Q® Direct 8/16 System 31
Rinsing the RO Cartridges
Rinse the RO
Cartridges
The RO Cartridges must be flushed and rinsed when the Milli-Q® System is installed.
Failure to do this results in poor water quality.
Procedure
Follow the steps below to flush and rinse the RO Cartridge(s).
Step
Action
Diagram
1
Start in STANDBY Mode.
2
•
Select Menu.
• Press .
3
•
Select Maintenance.
• Press .
4
•
Select Install new RO.
• Press .
Continued on next page