Milli-Q Direct 8 - Registering EXAMINE INLET STRAINER Message Timer

Milli-Q® Direct 8/16 System 41
Registering EXAMINE INLET STRAINER message timer
Introduction
• The timer used for cleaning the Inlet Strainer must be reset when the
Water System is installed.
• If this is not done, then the message indicating that the message EXAMINE INLET
STRAINER is shown too early.
Procedure
This procedure shows how to reset the timer used for the message EXAMINE INLET
STRAINER.
Step
Action
Diagram
1
Start in STANDBY Mode.
2
•
Select Menu.
• Press .
3
•
Select Maintenance.
• Press .
4
•
Select Clean Strainer.
• Press .
Continued on next page