Milli-Q Direct 8 - Description of Standby Menu

Milli-Q® Direct 8/16 System 49
Description of Standby Menu
Maintenance
The Maintenance Menu is described below.
Diagram 1
Diagram 2
Item
Description
Install Pretreatment
Used to reset Alert message REPLACE EXTERNAL
PRE-TREATMENT.
Clean Strainer
Used to reset Alert message EXAMINE INLET
STRAINER.
Install Progard®
Used to see general information about the Progard®
Cartridge exchange.
Install new RO
Used to start a flush and rinse of a new RO
Cartridge.
Install UV 254 Lamp
Used to reset Alert message REPLACE 254 NM
LAMP.
Install UV 185 Lamp
Used to reset Alert message REPLACE 185 NM
LAMP.
Install Q-Pak®
Used to see general information about the Q-Pak®
pack exchange.
Install POD Pak
Used to reset Alert message REPLACE POD PAK.
Install ASM UV
Used to reset Alert message REPLACE ASM UV
LAMP
Reset RO CL2 Cleaning
Used to reset Alert message PERFORM RO CL2
CLEANING at installation.
Continued on next page