Milli-Q Direct 8 - Page 79

Milli-Q® Direct 8/16 System 79
Replacing the Q-Pak® Pack, Continued
Removing
(continued)
Step
Action
Diagram
4
Remove the used Q-Pak® Pack.
5
The System will indicate that
the Q-Pak® Pack is removed in a
few moments.
Placing
Follow the steps below to install a new Q-Pak® Pack.
Step
Action
Diagram
1
Remove the covers on the 2
ports of the Q-Pak® Pack.
Look inside the ports.
Make sure the rubber O-rings
are firmly in place.
Wet the O-rings with water.
2
Push the top of the Q-Pak® Pack
into the ports on the System.
Push on the bottom of the
Q-Pak® Pack.
Continued on next page