Milli-Q Direct 8 - Page 53

Milli-Q® Direct 8/16 System 53
Description, Continued
Set Points
Diagram 1
Diagram 2
Item
Description
Pretreatment
Change set point for controlling the
frequency of the message REPLACE
EXTERNAL PRE-TREATMENT.
Strainer Frequency
Change set points for controlling the
frequency of the message EXAMINE INLET
STRAINER.
Tap Feed Cond
Change set point controlling the message
TAP FEED CONDUCTIVITY > SP.
RO Rejection
Change set point controlling the message
RO REJECTION < SP.
RO CL2 Cleaning
Change set point for controlling the
frequency of the message PERFORM RO CL2
CLEANING
Permeate Cond
Change set point controlling the message
PERMEATE C > SP.
Tank Refill
Change set point controlling the tank level
where the Milli-Q® System starts to refill
the tank.
Milli-Q® Product Res
Change set point controlling the message
MILLI-Q RES < SP, REPLACE Q-PAK.
Milli-Q® Product TOC
Change set point controlling the message
MILLI-Q TOC > SP.
Millipak®
Change set point controlling the message
REPLACE POD PAK IN XX DAYS (where
1
≤
XX
≤
15).
BioPak®, EDS-Pak®, POD Pak
See above.
Continued on next page