MIMAKI APC-130 User Manual

This chapter
describes the setting procedures of each functions, and how to operate the plotter
usefully.
Function by jog mode ....................................3-2
Paper cut ..................................................... 3-2
Axial correction of two positions .................. 3-3
Setting cut area ........................................... 3-4
Digitizing operation ...................................... 3-5
Perform Multiple Cutting (plotting) ................3-6
Investigate the causes of cutting
abnormality ...................................................3-7
Cut the sample data “Cut” ........................... 3-7
Cut the sample data “LOGO” ...................... 3-8
Cut the sample data “RECTANGLE” ........... 3-9
Distance correction .....................................3-10
Sheet feed ...................................................3-13
Hold .............................................................3-14
Setting function ...........................................3-15
Setting the COMMAND ............................. 3-16
Setting the INTERFACE ............................ 3-17
Setting the Device No. .............................. 3-18
Setting the ORIGIN SELECT .................... 3-19
Setting the AUTO CUT .............................. 3-20
Setting the ROTATION ............................. 3-21
Setting the BUZZER .................................. 3-22
Setting the PRIORITY ................................3-23
Setting the SHEET SENSOR ....................3-24
Setting the UP SPEED ..............................3-25
Setting the JOG STEP ...............................3-26
Setting the MM/INCH .................................3-27
Setting the PRE FEED ...............................3-28
Setting the FEED OFFSET ........................3-29
Setting the DUMMY CUT ...........................3-30
Setting the SHEET TYPE ..........................3-31
Setting the SORTING ................................3-32
Setting the OVER CUT ..............................3-35
Setting the START MODE .........................3-36
Setting the IP x Distance ...........................3-37
Setting the NR!PG CHANGE ..................3-38
Setting the PEN No. ASSIGN ....................3-39
Setting the Tool Change ............................3-40
Initializing the Settings ...............................3-41
Output the setting list ..................................3-42
Output the received data in the ASCII
code ............................................................3-43
Switch the language display on the
screen .........................................................3-44
Chapter 3
Extended Functions

MIMAKI APC-130 Specifications

General

Brand	MIMAKI
Model	APC-130
Category	Plotter
Language	English