MIMAKI APC-130 - Page 83

3-33
3
Convenient use
6
Setting function
Setting the SORTING
1
Press the key in LOCAL mode.
2
Press to select [SET UP].
3
Press the key.
4
Press to select [SORTING].
5
Press the key.
6
Press to select "ON".
7
Press the key.
8
Press to select [AUTO FEED].
• When performing AUTO FEED, select "ON".
9
Press the key.
10
Press to select a set value of [AREA].
Set Value :OFF, 10 ～ 300cm (10cm step)
11
Press the key.
12
Press the key several times to end the setting.
• The set values are recorded even when the power has been turned OFF.
• When the set value has been changed, the data in the reception buffer is cleared.
• When the sorting function is set to ON, the reception buffer capacity decreases to about 20 MB.
SQUARE CUT <ENT>
SET UP <ENT>
COMMAND < e n t >
SORT I NG < e n t >
SORT I NG : OFF
SORT I NG : ON
AUTO FEED : OFF
AUTO FEED : ON
AREA : OFF
AREA : 1 0 cm