MIMAKI CJV330-160 - Page 213

Chapter 8 Troubleshooting
213
Error
number
Message Cause Corrective action
505 Media Jam • The media jam sensor
was triggered.
1. Remove the media in contact with the
carriage and reload with fresh media.
"Loading the Media"(P. 57)
2. Open the front cover and check for
anything that may obstruct carriage
movement.
509 HDC POSCNT • A problem was detected
with position control.
• Turn off the power on the machine
and turn it on after a while.
"Turning Off the Power"(P. 35)
50a Y Origin • A problem was detected
with Y origin detection
(initialization).
50c Check Media With
Sensor
• A problem was detected
with media width
detection.
1. Check the media loading position.
"Loading the Media"(P. 57)
2. Clean the media width sensor.
"Media Sensor Cleaning"(P. 166)
50f L-SCALE BLACK • A problem was detected
with the linear scale.
• Turn off the power on the machine
and turn it on after a while.
"Turning Off the Power"(P. 35)
516 Media Set Position R
(L)
• The media was loaded
outside the range of valid
positions.
1. Check the media loading position.
"Loading the Media"(P. 57)
2. Clean the media width sensor.
"Media Sensor Cleaning"(P. 166)
523 Check PR Sensor • The pinch roller position
detection failed.
• Turn off the power on the machine
and turn it on after a while.
"Turning Off the Power"(P. 35)
528 Pump Motor • A problem was detected
with the pump motor.
• Turn off the power on the machine
and turn it on after a while.
"Turning Off the Power"(P. 35)
546 CLPADJORG SNS • The clamp pressure unit
origin detection failed.
54b Media Press • Media retainer detection
failed.
1. Check the media loading position.
"Loading the Media"(P. 57)
2. Clean the media width sensor.
"Media Sensor Cleaning"(P. 166)
54c Vacuum Fan Err • A problem was detected
with the vacuum fan.
• Turn off the power on the machine
and turn it on after a while.
"Turning Off the Power"(P. 35)
559 Wiper End Sns Err • A problem was detected
with the cloth wiper
remaining level sensor.
1. Check to confirm no foreign matter is
present around the wiper unit.
2. Turn off the power on the machine and
turn it on after a while. "Turning Off
the Power"(P. 35)
55A XYSlitter
Y ORIGIN
• A problem was detected
with Y origin detection of
the XY slitter.
• Turn off the power on the machine
and turn it on after a while.
"Turning Off the Power"(P. 35)
55B XYSlitter
Clamp ON
• Backward Feed was
performed with [MENU] >
[Function Setting] >
[Finisher] set to [XY
Slitter].
• Use with the the XY slitter clamp
lever lowered (unclamped).
"Clamp lever of the XY
slitter"(P. 119)
8