MIMAKI CJV330-160 - Page 212

Chapter 8 Troubleshooting
212
Error
number
Message Cause Corrective action
44f Take-up Roll Sns Err • A problem was detected
with the take-up unit
sensor spindle.
1. Check to confirm the [Function Setting]
> [Take-up Unit] setting is "ON".
2. Check to confirm the media is loaded
correctly. "Loading the Roll
Media"(P. 62)
3. Check to confirm the take-up unit switch
functions properly. "Take-up
unit"(P. 58)
45a Failed Cutter unit joint • The carriage could not be
disconnected.
• Turn off the power on the machine
and turn it on after a while.
"Turning Off the Power"(P. 35)
45b Failed Cutter unit
detach
• Unable to connect to
carriage
45e Check PR/GR Position • A problem was detected
with the pinch roller
positions.
• Place the pinch rollers above the
grit rollers.
48a Detect winding failure • A problem was detected
with the take-up unit.
1. Check to confirm the [Function Setting]
> [Take-up Unit] setting is "ON".
2. Check to confirm the media is loaded
correctly. "Loading the Roll
Media"(P. 62)
3. Check to confirm the take-up unit switch
functions properly. "Take-up
unit"(P. 58)
48F XYSlitter
MOTOR X
• The X motor of the XY
slitter was overloaded.
1. Lower the XY slitter clamp lever
(unclamp). "Clamp lever of the XY
slitter"(P. 119)
2. Check to confirm the media is loaded
correctly. "Loading the
Media"(P. 122)
3. Check to confirm that the XY slitter X
cutter is correctly mounted.
"Mounting the X Cutter"(P. 130)
4. Raise the XY slitter clamp lever (clamp).
491 XYSlitter
X CURRENT
• An overcurrent was
detected in the X motor of
the XY slitter.
490 XYSlitter
MOTOR Y
• The Y motor of the XY
slitter was overloaded.
492 XYSlitter
Y CURRENT
• An overcurrent was
detected in the Y motor of
the XY slitter.
493 XYSlitter
TBar Abnormal
• A problem was detected
with position control of the
XY slitter tension bar.
1. Lower the XY slitter clamp lever
(unclamp). "Clamp lever of the XY
slitter"(P. 119)
2. Check to confirm the media is loaded
correctly. "Loading the
Media"(P. 122)
3. Raise the XY slitter clamp lever (clamp).
494 XYSlitter
TBar Position
495 XYSlitter
TBar Shelter
• The XY slitter tension bar
is still at the retract
position.
1. Lower the XY slitter clamp lever
(unclamp). "Clamp lever of the XY
slitter"(P. 119)
2. Check to confirm whether the tension
bar is at the retract position.
3. Check to confirm the media is loaded
correctly. "Loading the
Media"(P. 122)
4. Raise the XY slitter clamp lever (clamp).
504 CLAMP UP • The clamp lever is lifted. • Lower the clamp lever.