MIMAKI CJV330-160 - Page 214

Chapter 8 Troubleshooting
214
Error
number
Message Cause Corrective action
• The XY slitter clamp lever
was left up (clamped) with
[MENU] > [Function
Setting] > [Finisher] set
other than to [XY Slitter].
55C XYSlitter
Clamp OFF
• The XY slitter clamp lever
was left down
(unclamped) with [MENU]
> [Function Setting] >
[Finisher] set to [XY
Slitter].
• Use with the XY slitter clamp lever
raised (clamped). "Clamp lever
of the XY slitter"(P. 119)
602 Ink End • The ink has run out. • Replace with new ink. "When
Ink End is Displayed"(P. 43)
604 Check Waste Ink tank • The waste ink tank count
exceeded the preset value
(80 %).
1. Check the waste ink levels in the waste
ink tank. "When "Check Waste Ink
tank" message appears"(P. 192)
2. Replace the waste ink tank, then reset
the waste ink level. "Replacing the
Waste Ink Tank"(P. 193)
608 Wrong Ink IC • An error occurred with the
information on the ink IC
chip.
1. Check to confirm the ink IC chip was
inserted correctly. "Mounting the
ink"(P. 46)
2. Turn off the power on the machine and
turn it on after a while. "Turning Off
the Power"(P. 35)
3. Replace with new ink. "Replacing
Ink"(P. 44)
60a Excess Ink Usage • The ink usage amount
stored in the ink IC chip
exceeded the preset
value.
• The ink IC chip was not
replaced during ink
replacement. (The same
chip continued to be
used.)
• The machine was used
with nozzle clogging.
• Replace with new ink. "When
Ink End is Displayed"(P. 43)
60c Ink Type • The ink type registered on
the IC chip is different
from the ink type filled.
• Insert an ink IC chip for the correct
ink type. "Mounting the
ink"(P. 46)
627 Set Eco-cases • The ink IC chip could not
be read for a certain
period of time.
1. Check to confirm the ink IC chip was
inserted correctly.
2. Turn off the power on the machine and
turn it on after a while. "Turning Off
the Power"(P. 35)
629 Expiration Near • The ink has expired. • Replace with new ink or use up as
quickly as possible. Printing is
possible. "When Ink End is
Displayed"(P. 43)
62a Expiration Over • The ink is two months
past its expiration date
and cannot be used.
• Replace with new ink. Printing is not
possible. "When Ink End is
Displayed"(P. 43)