MIMAKI CJV330-160 - Page 216

Chapter 8 Troubleshooting
216
Error
number
Message Cause Corrective action
806 FW/SIO bit • A communication error
was detected between the
boards.
808 FW/STP-MTR** • A problem was detected
with the main PCB.
811 FW/SIO read • A communication error
was detected between the
boards.
81b FW/STACK OV • A problem was detected
with the main PCB.
828 PRG ERR L*****
901 Operation Error • The function is disabled
due to an error.
• Check the error details.
– Media Undetected
– Ink error
– Waste Ink Tank, etc.
902 Data Remain • Print (RIP) data was
received.
• Switch to REMOTE mode and start
printing or clear the data and abort
printing.
90f Print Area Short • The media is too small for
the print.
• Replace with wider or longer media.
• If the printable area is reduced due
to a shift in the origin, move the
origin to increase the size of the
printable area.
b1a PCB BaseIO • A communication error
was detected between the
boards.
• Turn off the power on the machine
and turn it on after a while.
"Turning Off the Power"(P. 35)
b1b BaseIO PCB Vpow-s • A problem was detected
with the Base IO PCB
power supply.
b1c BaseIO PCB V24
b1d BaseIO PCB V24-A
b1e PCB BaseIO-F** • The Base IO PCB fuse
blow was detected.
• The fuse must be replaced. Contact
your local distributor, our sales
office, or service center.
b1f PCB HDCE* • A communication error
was detected between the
boards.
• Turn off the power on the machine
and turn it on after a while.
"Turning Off the Power"(P. 35)
b2f PCB HDCE*-F* • A blown fuse on the
HDCE PCB was detected.
• The fuse must be replaced. Contact
your local distributor, our sales
office, or service center.
b32 INKCT PCB V2R5 • A problem was detected
with the ink supply PCB
power supply.
• Turn off the power on the machine
and turn it on after a while.
"Turning Off the Power"(P. 35)
b33 INKCT PCB V3R3
b3f BaseIO Unconform • The PCB could not be
detected.
b49 PCB HDCE-
VHVFET[12]
• A problem was detected
with the HDCE PCB
power supply.
• Turn off the power on the machine
and turn it on after a while.
"Turning Off the Power"(P. 35)
b4b HDCE* PCB V1R2
b4c HDCE* PCB V2R5