Chapter 2 Printing
63
2
Move the rear left roll holder to the roll setting position.
• Unscrew the roll holder retaining screw before moving.
• JV/CJV can hold three rolls. "Feed unit (JV/CJV)"(P. 61)
• JV: The roll holder set position label is placed on the roll guide of the feed unit. Use it as a
reference to set the roll holder.
2 Inch Roll Media
3 Inch Roll Media
Set Position
Roll Holder
S et P o si t i o n
R ol l H ol d e r
3 I n c h R o l l M e d i a
2 I n c h R o l l M e d i a
Set the roll holder reference line within the area
indicated by the arrows as shown above.
Setting position for 3-inch roll
Setting position for 2-inch roll
Reference
• CJV: No roll holder set position label is placed on the roll guide. Use the pinch roller guide marks
as references to set the roll holder.
Setting position for 3-inch roll
Setting position for 2-inch roll
Set the roll holder within the pinch roller guide
marks.
• TS: The roll holder set position label is placed on the leg stay of the machine. Use it as a reference
to set the roll holder.
Roll Holder
Set Position
3 Inch Roll Media
2 Inch Roll Media
R ol l H ol d e r
S et P o si t i o n
3 I n c h R o l l M e d i a
2 I n c h R o l l M e d i a
Set the roll holder reference line within the area
indicated by the arrows as shown below.
Setting position for 3-inch roll
Setting position for 2-inch roll
Reference
3
Tighten the retaining screw on the rear left roll holder.
2
To Next Page
Loading...
