MIMAKI JFX500-2131 - Replace the Ink Absorber

Replacing consumables
4-25
1
1
1
4
Routine Maintenance
Replace the Ink Absorber
Replace the ink absorber in the cap section before it gets dirty and can no longer absorb ink properly.
1
Press the key in LOCAL.
2
Press the key.
3
Press to select [HEAD MAINT.].
4
Press the key.
• Carriage will move to the left end of this device.
5
Open the cover and remove the ink absorber
holder.
• Remove the 8 screws and remove the cover and ink
absorber holder.
6
Replace the ink absorber.
7
Return the ink absorber holder and cover to their original positions and press the
key.
• A ink absorber (SAP-0215/SAP-0216/SAP-0217) is an option.Buy one through the dealer in your
region or at our service office.
• Be sure to wear the supplied goggles and gloves when maintaining the capping station.Otherwise,
you may get ink in your eyes.
• Do not move the carriage out of the capping station by hand.When it is desirable to move the
carriage, press the key to execute the carriage-out.
MAINT.
CARR I AGE OUT
[ENT]
MAINT.
MOV E P O S I T I ON
:STATION MAINT.
MOV E P O S I T I ON
:HEAD MAINT.
CAP absorber
front side
CAP absorber
front side
CAP absorber under side