MIMAKI JFX500-2131 - Setting UV Mode

3-13
1
1
3
Convenient use
5
6
Setting UV mode
Set the intensity of the UV lamp on the LED UV device.
Adjusting the intensity set in RIP
1
Press the key in LOCAL.
2
Press the key.
3
Press to select [UV MODE].
4
Press the key.
5
Press to select [PATTERN].
6
Press the key.
7
Press to select [HOST].
• To print at the intensity set in the printer, select [MANUAL].
8
Press the key.
9
Press to set the adjustment value for the
intensity of the LED UV device.
Set Value : -50% to +50%
• If the value is set to 0%, the value specified in RIP is applied.
• Setting a negative value reduces the intensity; setting a positive
value increases the intensity.
10
Press the key.
11
Press the key several times to end the setting.
FUNCT I ON
SETUP [ ENT ]
SETUP
FEED COMP . [ ENT ]
SETUP
UV MODE [ ENT ]
UV MODE
:PATTERN
UV MODE
:PATTERN
UV MODE
:HOST
UV MODE
:HOST
UV MODE
LIGHT ADJUST : 0%
UV MODE
LIGHT ADJUST : 10%
SETUP
UV MODE [ ENT ]